In nearly all situations, most individuals spend quite a lot of money buying their lift truck. Therefore, it is really important to take proper care of it so as to protect your investment well into the long run. It is a great idea to know the procedures which are undertaken during taking care of and maintaining this machine.
By starting up the forklift and listening closely how it runs is among the best ways to tell how good the engine is performing. Like for instance, if there are any knocks or misses, the equipment is faulty and this must raise several concerns. In addition listen closely for any squealing noise which come from the belts since these noises will provide you with a lot of information.
Some of the main parts needing attention during maintenance consist of the gauges, horn, safety warning devices, the overhead guard and the lights. Any faulty parts or burnt out light bulbs must be replaced as soon as they are noticed. It is also vital to check the wiring.
After the above parts have been checked thoroughly, proceed to the battery compartment to be able to see if the terminals are clean. If the terminals are not clean, be sure to clean them properly. Every battery cell needs to be inspected so as to make sure that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machinery and then change the filters. The hydraulic filter, the transmission filter and the fuel filters should be regularly replaced. Before fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
After the oil change is finished and the filters have been replaced, a visual inspection of the drive axle has to be carried out. If there is a grease fitting on the axle make certain to apply some grease. Check the engine belts for any frays or cracks. If you find any, fix the issue accordingly. After that, check each and every other component of the equipment like the wheels. If any kind of fault or issue is detected, be certain to deal with it immediately in order to make certain the machine is running at its safest and optimum levels.