Change a Propane Tank
Forklifts fueled by propane are common inside warehouse settings. These forklifts have a propane mount located at the back of the operator. These tanks need to be replaced from time to time since they have limited lifespans. Operators of forklifts must utilize caution when handling propane tanks. Compressed gases are dangerous, especially since the gas is flammable. Utilize caution when replacing and removing propane tank to prevent being injured.
1 If there is a need to change the propane tank, the first step is to stop the forklift, then turn the tank valve off. The lift truck must be left on until the engine dies. This process burns off the gas inside the transfer hose that connects the tank and the engine. Prior to taking the second steps, put on the correct safety equipment, like for example insulated gloves made of either neoprene or leather. It is important for you to protect your skin from contact with the compressed gas, that is very cold.
2 The tank hose needs to be disconnected, followed by removing the tank from its holding straps. When putting in a new tank, reconnect the holding straps and reconnect the hose at the valve of the tank by tightening the nut.
3 You can check for leaks by applying soapy water to the valve and slightly opening it. Leaking gas will cause bubbles to foam around the value. If this occurs, check the connection hose at the nut and the valve area. Re-tighten the connecting nut if you detect any leaks in the area of the valve, and then perform the leak inspection procedure again. Persistent leaks mean that the connecting hose and nut must be replaced. However, if replacing the nut and hose still does not stop the leak, the tank must be replaced.
4 Open the valve all the way to allow the gas to fill the connecting hose. Then you could start the forklift and resume operating.